Pax 2 FAQs: https://www.paxvapor.com/support/pax-2-faq/
Warranty info: https://www.paxvapor.com/support/warranty/#PAX210
In The Box:
- The PAX 2
- Two silicone mouthpieces – a flat one, flush with the top of the device, and one raised option
- One magnetic charging cradle with USB cord
- PAX 2 cleaning kit with isopropyl alcohol & pipe cleaners
Charging Your Pax 2
Before using your device you’ll need to make sure it’s charged. Connect the cradle and cord provided to your computer or outlet adaptor, then place PAX 2 on the cradle to charge. Once PAX 2 is on the cradle, watch for the pulsing white petals. The more petals lit, the more charge it has. PAX 2 is fully charged when all four petals stop pulsing and turn solid.
Now that your unit is charged, you’re ready to get started. Remove the magnetic oven lid and pack with your finely ground loose leaf material. You will get the best vapor when the oven is packed firmly – and at least halfway full. You can pack and fill your device to the top edge of the oven for a longer session. You can also use the lid to firmly tamp down the contents of the oven. Once your oven is nicely packed, replace the lid.
PAX comes fitted with a flat mouthpiece, but also included is a raised option. Try both to find out which you prefer. They’re easy to switch out.
Powering The Device On
A short press in the center of the mouthpiece will turn your device on. You can also remove the mouthpiece to power on. PAX 2 heats in as little as 30-60 seconds. The LED petals will pulse purple while heating. Once the LED lights turn green, you’re good to go. A gentle draw is best to start. Ensure your lips are placed around and not directly in the opening of the mouthpiece. When drawing, PAX 2’s green lights will pulse faster than usual.
One full oven should last anywhere between 10 and 25 draws, depending on your temperature setting.
PAX 2 users have told us they enjoy increasing the temperature setting during a session. There are four settings available to customize your experience. To adjust the temperature setting, hold down the mouthpiece button for an extended press while the device is on.
You’ll know you’re in temperature set mode once the LED petals change from green to yellow, then orange and finally, red as you increase the temperature setting. Cycle through the settings by pressing in the center of the mouthpiece.
Exit temperature set mode by holding down on the mouthpiece button for an extended press, or by shaking the device.